萬心蓄電池6FM-100 12V100AH廠家銷售、萬心蓄電池6FM-100 12V100AH廠家銷售、萬心蓄電池6FM-38 12V38AH廠家銷售、萬心蓄電池6FM-38 12V38AH廠家銷售、萬心蓄電池6FM-65 12V65AH、萬心蓄電池6FM-100 12V100AH、萬心蓄電池6FM-120 12V120AH、萬心蓄電池6FM-24 12V24AH

銷售專線：13718107657  孫順

適用對象: 計算機系統

1、 免補水、維護簡單
采用特殊設計克服了電池在充電過程中電解失水的現象，電池在使用過程中電液體積和比重幾乎沒有變化，因此電池在使用壽命期間完全無需補水，維護簡單。
2、 密封安全、安裝簡單
電池內沒有流動的電液，電池立式、側臥安裝使用均可，無電液滲漏之患，而且在正常充電過程中電池不會產生酸霧。因此可將電池安裝在辦公室或配套設備房內，而無需另建專用電池房，降低工程造價。
3、 使用壽命長
采用了耐腐性良好的鉛鈣合金板柵，在25℃的環境溫度下，正常浮充壽命可達10年以上。
4、 高功率放電性能好
采用了內阻值很小的優質極板和玻纖隔板，而且裝配較緊，使得電池內阻極小。在-40℃~60℃溫度范圍內進行大電流放電，其輸出功率比常規電池可高出15%左右。
5、 安裝使用方便
電池出廠時已經完全充電，用戶拿到電池后即可安裝投入使用。
萬心蓄電池規格 參數：
型號  額定電壓（V）  額定容量（Ah）  尺寸（mm）  重量（kg）  端子  
C20  C1  長  寬  高  總高  
6FM-24  12  24  14  165  125  177  180  10  M6  
6FM-38  12  38  22  196  165  176  178  13.8  M6  
6FM-50  12  50  28  257  166  170  176  18.2  M6  
6FM-65  12  65  37  322  167  170  175  22.5  M6  
6FM-80  12  80  45  288  171  216  227  28.2  M6  
6FM-100  12  100  56  377  174  217  227  33  M6  
6FM-120  12  120  68  407  174  216  227  39.8  M6  
6FM-150  12  150  84  497  203  225  247  53.8  M6  
6FM-200  12  200  112  497  259  224  247  70  M6  
萬心蓄電池使用說明：
  1、 售前技術咨詢：可幫助用戶設計，無償提供技術咨詢。 

  2、 交貨日期及交貨地點：保證在規定時間內按時送貨到用戶指定地點。 

  3、 安裝督導：按需方要求負責設備的安裝、調試、技術指導。 

  4、 產品的初驗、試運行、終驗：積極配合需方設備的初驗、試運行、終驗工作，并可根據用戶的要求對產品的性能進行測試，保證設備正常運行。 

  5、 產品保修期：保修一年，在保修期內，我方將無償更換由于原材料、設計及制造工藝等技術問題和質量問題而發生故
障的產品，并在買方無法處理的主要問題上，免費提供更換服務，及時解決產品存在的各種問題和產品的修理問題。 
萬心蓄電池用注意事項
1.確認使用條件符合廠家的規格要求。
2.初次使用或長期放置后使用一定要充電。
3.UPS用的電池是用于浮充使用,假如頻繁使用蓄電池(類似循環使用),將嚴重影響蓄電池的涓流
 壽命。
4.定期進行蓄電池檢查。
5.如發現電槽變形及漏液等現象,請不要使用,應以更換。
6.端子處假如連線不緊,有引發火災的危險性。 
7.建議如無斷電情況可3～6月做一次放電,如發現蓄電池的充電電壓或放電特性等有異常時,請
 更換此蓄電池。
8.電池容量低于初期容量的50%時,應及時更換電池。

Widely used soft switching technology, which is different from conventional resonant ZUS and ZCS soft switching, has been widely adopted to reduce switching losses and increase switching frequency. The soft switch is a lossless snubber circuit. It can not only soften the switching process, but also has the characteristics of simple circuit, no additional resonant network and low cost. The input end of the installation of efficient input filter and active power factor corrector, and the series parallel compensation technology, to reduce the distortion of input current, reducing the pollution of UPS power to the power, make it to the green power conversion type development.

(2) for the realization of UPS power output transformer is small, reducing the size of the filter, reduce electromagnetic interference, prevent high frequency transformer saturation in South Korea using the series resonant inverter, through the isolation transformer and inverter high frequency link UPS.

(3) digital control has become the mainstream of the development of new UPS control technology, that is, the extensive use of digital processor DSP, as much as possible to make the control circuit fully microprocessor. Because the digital controller has the advantages of high precision, strong anti-interference ability, easy to realize the detection of UPS fault diagnosis and isolation, easy to realize remote control, easy to plug to realize multi UPS parallel and hot, easy to realize monitoring and management of the battery, that is to say, the involvement of the computer can make UPS achieve intelligent management that can make the power in optimum operating state.

(4) the storage battery is the heart of UPS. At present, UPS usually uses the maintenance free sealed lead acid battery, and the United States also uses the high power lead air standby power supply (RPU) to replace the battery. In order to increase the service life of the battery, the use of a three stage battery management solutions, namely a constant current equalizing charge, float charge and natural discharge in three stages, in order to prevent overcharge and overdischarge. Now, the battery management system based on microprocessor monitoring technology has been introduced. The battery charging and discharging status has been observed at any time, and double protection of battery charging and discharging has been carried out.

(5) redundancy technology and hot insertion technique are adopted.

(6) the management system of intelligent UPS is adopted. The so-called intelligent UPS, refers to the traditional UPS hardware interface connected with the computer, with special design software, to provide double protection of computer and data, to ensure the completion of the basic UPS functions, but also detect all faults, display and processing, fully realize the network monitoring and management.