A10VSO18DR/31R-PPA12NOO軸向柱塞變量泵,無錫福力德柱塞泵廠.

 A10VSO與0A10VO變量柱塞泵

Variable Displacement Piston Pump A10VSO and A10VO

概述Overview

本產品是一種斜盤式軸向柱塞變量泵，專為開式回路液壓驅動設計的，采用通軸結構，額定工作壓力可達28MPa。

This product is an axal piston pump in swash plate design for hydrostatic drives in open circu't operation. Withthrough- shaft construction, its rated operating pressure is up to 28MPa.

A10V變量柱塞泵特點:

※泵的流量正比于泵的轉速和排量，通過調節斜盤擺角調節排量，實現無級變量:

※通軸結構，可形成組合泵:

※中心彈簧回程機構;

※平面配流，柱塞困繞主軸平行布置:

※優良的吸入性能:

※額定工作壓力可達28MPa;

※控制響應時間短:

※低噪聲;

※長壽命;

※高的功率/重量比;

※驅動軸能承受軸向及徑向負載;

※安裝法蘭有ISO和SAE標準兩種形式;

※軸仲有多種形式;

※工作油口有兩側與后部兩種布置形式;

※安裝位置可選;

※可用HF液體工作，但運行參數有所降低。

控制裝置Control Devices

1.直接控制DG Direct Control DG

通過在油0X施加一個外部切換壓力使變量泵達到最小擺角?？刂?/span>油可直接供給控制活塞，需要的最小壓力為50bar。變量泵只能在

Vomn與Vnma之間切換。

注意:油DX所需的切換壓力與壓力油0B的實際工作壓力直接相關。

An external switching pressure can be appled to Port X to minimize the swivel angle of the vanable pump. Control oil can be supplied directly for the control piston under the necessary minimum pressure of 50 bar. The variable pump can only be shited between Vom and Vow Note: the switching pressure needed at Port X is in direct correlation wth the actual working pressure of Pressure Port B.

2、壓力控制DR Pressure Control DR

壓力控制使泵的出口壓力保持恒定，因此支量泵只提供液壓累統的執行元件所需的液壓油流量。出口壓力可在控制閥上無級設定。

The pressure control will keep the outlet pressure constant.Therefore, the varable pump only delivers as much fluid as required by the actuator elements of the hydrauic system.The oulet pressure can be set through stepless adjustment on the control valve.