高速防撞墻模具在工程中工程中使用更廣泛的長度為1米，因為其體積與其他模具相比十分嬌小，重量也相對較輕，所以可以自由地進行組裝，一般的工程只需要40到50個一米長的模具就可以完成，直接在施工現場進行拼裝和澆筑即可，十分方便快捷。

使用說明：

在使用上，由于多用于現澆生產，一旦澆筑上混凝土就沒有辦法再次移動，所以要注意使用前把模具放到合適的位置上。高速防撞墻模具還有一個特點就是當混凝土表面凝固脫離模具不會坍塌就可以拆除模具進行下一段防撞墻的制作了，所以生產也就更加快速，但是也需要拆模更加簡便，所以要注意在注漿前需要在模具內均勻刷上脫模劑，以便于脫模。主要灌漿后的混凝土還沒有成型，但已經暴露在施工現場了，為了防止剮蹭影響防撞墻的美觀和實用，需要在其表面覆上一層塑料薄膜。High speed anti-collision wall mold is more widely used in engineering, the length is 1 meter, because its volume is very small compared with other molds, and the weight is relatively light, so it can be assembled freely. General engineering only needs 40 to 50 one meter long molds, which can be directly assembled and poured in the construction site, which is very convenient and fast.

instructions:

In use, because it is mostly used in cast-in-place production, once the concrete is poured, there is no way to move it again, so we should pay attention to put the mold in the right position before use. Another feature of high-speed anti-collision wall mold is that when the concrete surface solidifies and breaks away from the mold, the mold can be removed to make the next section of anti-collision wall, so the production will be faster, but the mold removal also needs to be easier, so it is necessary to pay attention to brush the release agent evenly in the mold before grouting, so as to facilitate the release. The main grouting concrete has not been formed, but it has been exposed in the construction site. In order to prevent the scratch from affecting the beauty and practicality of the anti-collision wall, it is necessary to cover a layer of plastic film on its surface.