The perlite separates the heat preservation board (FSG hatred water heat preservation board) is take the inflated pearlite bulk as an aggregate, joins the water-repellent and the cementing agent carries on the heat insulation waterproofing heat preservation board which working procedures and so on configuration, screening, compression formation, drying make. The FSG hatred water heat preservation board has solved each kind of building roofing heat preservation, the heat insulation and the waterproof function effectively in a body's technical difficult problem, saved the massive constructions and the service fund.product characteristic:The nature is light, and heat preservation heat insulation performance fine fire protection. Dustproof. Moisture-proof, does not distort the modification, not rottenly mildewy, the non-toxic tasteless hatred water performance to be good, hates Shui Lvke to reach above 98% to construct safely easy and feasible, the roofing and the wall surface glue may the natural ore be raw materials, has the good environment-protective.

粘貼：將中信巖能無機納米絕燃保溫板粘貼到主體墻面上，粘貼時要揉壓，不要直壓或硬壓，確保粘結漿料充滿所有孔隙并與主體100%満粘。同時注意與上下左右保溫層表面的平整度。打釘：待初凝后，用沖擊鉆在在每塊中信巖能無機納米絕燃保溫板 四角的兩邊8cm垂直交匯處打4個孔（直徑為6～8mm）至主體內大于2.5cm處，用長度大于6cm（根據保溫板的厚度決定錨釘?shù)拈L(zhǎng)度）的帶塑料套的錨釘加固。然后整體鋪設網格布，做抗裂砂漿層。、既有建筑保溫節能改造應先清除原粉刷層,對舊墻松動、風化部位應剔鑿清除干凈,用1:2.5水泥漿料嵌牢補平.其它程序及做法均同新建房屋做中信巖能無機納米絕燃保溫板做法。（按施工規程要求施工）。

以氣凝膠膨脹珍珠巖為骨料,P·O 42.5級水泥和熟石膏的混合物為膠結材料,添加可再分散性乳膠粉、羥丙基甲基纖維素制備保溫板。使用單因素法分析了硅酸鹽水泥和熟石膏的配料及抗壓強度的關系;采用正交試驗法研究了配料用量和保溫板抗壓強度、導熱系數的關系。制得保溫板的導熱系數低至0.045 W/(m·K),抗壓強度達到0.54 MPa。試驗采用X射線衍射分析了膠結材料的反應,使用紅外光譜技術研究了氣凝膠膨脹珍珠巖的疏水特性。 以導熱系數極低的物質氣凝膠為研究對象,使其與膨脹珍珠巖復合,制成氣凝膠膨脹珍珠巖。對比級配與非級配氣凝膠膨脹珍珠巖膠凝材料的傳熱性能,建立數值模型模擬氣凝膠膨脹珍珠巖的粒徑級配在傳熱中的作用,推導出氣凝膠膨脹珍珠巖膠凝材料的傳熱規律。根據氣凝膠膨脹珍珠巖的特性研制建筑保溫材料,測試這種新型保溫材料的導熱系數和力學性能。計算太原地區氣象參數下氣凝膠膨脹珍珠巖保溫材料圍護建筑的年制熱制冷能耗值為57.45 kWh/m2,與普通圍護建筑109.90kWh/m2相比,實現能耗的大幅降低。本文研究的具體內容如下:(1)使用不同硅源、酸堿催化劑和改性置換劑研制低導熱氣凝膠。

FSG憎水樹脂膨脹珍珠巖保溫板屋面隔熱施工環保安全措施1、如無女兒墻者，四周腳手架應高出FSG憎水樹脂膨脹珍珠巖保溫板屋面1m，并有安全網圍欄， 如無樓梯上FSG憎水樹脂膨脹珍珠巖保溫板屋面，應由有斜橋的腳手架上下，不得攀爬腳手架。2、鋼井架進出口應有圍欄、操作人員不得隨意向四周拋雜物下地，以免傷人。3、如無女兒墻者，特別要注意檐口部位的施工安全，不要向后退施工，以免墜落。4、材料進場堆放整齊，標識清楚。、工完場清，避免材料飛揚。FSG憎水性膨脹珍珠巖外墻內保溫的施工原理,施工工藝和成品保護措施,既保證了施工安全,又取得了滿意的經濟效益和社會效益.