進口全自動反沖洗排污過濾器品牌德國洛克

一、進口全自動反沖洗排污過濾器概述：

德國《LOCKE》洛克-進口全自動反沖洗排污過濾器采用高強度的不銹鋼網，具有處理量大，使用壽命長、清洗效率高等特點。本機采用智能壓差控制、定時控制自動反沖洗過濾網。當過濾器進出口壓差達設定值或定時器達到設定時間時，電動控制箱發出信號驅動閥門轉動，同時排污閥打開。這時水流被迫從過濾網筒的入口段孔進入濾筒外側與殼體夾層，反向從濾網外側沖洗粘附在網孔上的雜質，達到清潔過濾網的目的，當過濾器進出口壓差恢復正?；蚨〞r器設定時間結束后，電機停止轉動，電動排污閥關閉。整個過程中，液體不斷流，實現了連續化、自動化生產。

Locke, Germany - the imported full-automatic backwash blowdown filter adopts high-strength stainless steel mesh, which has the characteristics of large processing capacity, long service life and high cleaning efficiency. The machine adopts intelligent differential pressure control and timing control to automatically backwash the filter screen. When the pressure difference between the inlet and outlet of the filter reaches the set value or the timer reaches the set time, the electric control box sends a signal to drive the valve to rotate, and the drain valve opens at the same time. At this time, the water flow is forced to enter the interlayer between the outside of the filter drum and the shell from the inlet section hole of the filter drum, and the impurities adhered to the mesh are flushed from the outside of the filter screen in reverse direction, so as to clean the filter screen. When the pressure difference between the inlet and outlet of the filter returns to normal or the timer setting time is over, the motor stops rotating, and the electric drain valve is closed. In the whole process, the liquid is not cut off, realizing continuous and automatic production.

二、進口全自動反沖洗排污過濾器特性：

①過濾精度高，出水水質穩定；

②通過自身的檢索和應變功能，實現自動反沖洗，可應對不穩定的水質波動，無需人工干預；

③控制系統反應靈敏，運行精確，具有壓差和時間雙重設定功能，可以根據不同水源和過濾精度靈活調整反洗壓差或時間設定值；

④清洗高效、徹底，濾網可完全恢復初始狀態，因而可終身使用，無需更換；

⑤反沖洗的同時不中斷正常產水，連續運行，穩定可靠；

⑥反沖洗歷時短，反洗水耗僅為正常產水量的0.001-0.002％，省水、省電、節約能源；

⑦結構設計緊湊合理，占地面積小，安裝移動靈活方便；

⑧設備易損件少，無耗材，運行維護費用低，操作管理簡單；

⑨應用領域廣，可適用不同原水水質和用水要求。

① High filtration precision and stable effluent quality;

② Through its own retrieval and strain function, automatic backwashing can be realized, which can deal with the unstable water quality fluctuation without manual intervention;

③ The control system has the functions of sensitive response, accurate operation, dual setting of pressure difference and time, and can flexibly adjust the backwash pressure difference or time setting value according to different water sources and filtering accuracy;

④ The filter screen can be completely restored to its original state, so it can be used for life without replacement;

⑤ At the same time of backwashing, normal water production is not interrupted, continuous operation is stable and reliable;

⑥ The backwashing water consumption is only 0.001-0.002% of the normal water production, saving water, power and energy;

⑦ Compact and reasonable structure design, small floor area, flexible and convenient installation and movement;

⑧ Less wearing parts, no consumables, low operation and maintenance cost, simple operation and management;

⑨ It has a wide range of applications, and can be applied to different raw water quality and water requirements.

三、進口全自動反沖洗排污過濾器工作原理：

1、定時反沖洗排污：定時清洗排污，可設定時間為2-24小時動作。當定時時間到，電動執行器打開排污閥，過濾器進行排污30-60秒，然后電動執行器將轉向蝶閥旋轉90°至阻擋濾筒位，改變水流途徑，進行反沖洗排污30-60秒。轉向蝶閥復位，繼續排污3-5秒，然后關閉排污口。

2、壓差控制排污：壓差控制器動作值可設定為0.03-0.07MPa,當過濾器前后壓差達到壓差控制器設定值時，壓差控制器動作，過濾器排污閥開啟，30-60秒結束，轉向蝶閥復位，繼續排污3-5秒，關閉排污閥。

3、手動控制：通過控制箱上按鈕，可直接控制清污、排污。

1. Regular backwashing and blowdown: regular cleaning and blowdown, with a set time of 2-24 hours. When the timing time is up, the electric actuator will open the blowdown valve, and the filter will blow down for 30-60 seconds. Then the electric actuator will rotate the steering butterfly valve 90 ° to block the filter cartridge position, change the water flow path, and carry out backwash blowdown for 30-60 seconds. Reset the steering butterfly valve, continue to drain for 3-5 seconds, and then close the drain outlet.

2. Differential pressure control blowdown: the action value of the differential pressure controller can be set to 0.03-0.07mpa. When the differential pressure before and after the filter reaches the set value of the differential pressure controller, the differential pressure controller will act, the filter blowdown valve will open, 30-60 seconds will end, the steering butterfly valve will reset, the blowdown will continue for 3-5 seconds, and the blowdown valve will be closed.

3. Manual control: the button on the control box can directly control the cleaning and blowdown.

四、進口全自動反沖洗排污過濾器參數：

1、公稱通徑：DN50-DN800

2、公稱壓力：1.0Mpa-2.5Mpa

3、適用溫度：-10℃≤T≤125℃

4、適用介質：水、油

5、閥體材質：碳鋼、不銹鋼

6、連接方式：法蘭連接

7、過濾效率：80%-99%

8、壓力損失：≤0.002Mpa

9、處理水量：4.4T/H-2450T/H

1. Nominal diameter: dn50-dn800

2. Nominal pressure: 1.0mpa-2.5mpa

3. Applicable temperature: - 10 ℃ ≤ t ≤ 125 ℃

4. Applicable medium: water and oil

5. Valve body material: carbon steel, stainless steel

6. Connection mode: flange connection

7. Filtration efficiency: 80% - 99%

8. Pressure loss: ≤ 0.002mpa

9. Water treatment capacity: 4.4t/h-2450t/h