拉線盤模具 電力拉線盤模具 廠家根據圖紙定制 拉線盤模具主要工藝流程是按照當前對于不同地區使用拉線盤預制塊的制作習慣而定的，從拉線盤模具的外形上可以看出來，該模具的主要樣式是以兩側坡型，中間帶有圓孔的為主，這樣的話在具體模具生產之前，會仔細核對長度、寬度、厚度等。按照對拉線盤預制塊的制作方式，這種鋼模具可以采用兩種自作形式，一種是平模形式，采用立模方式。

According to the drawing, the main process flow of the cable tray mould customized by the power cable tray mould manufacturer is determined according to the current production habit of using the cable tray precast block in different regions. From the shape of the cable tray mould, it can be seen that the main style of the mould is the slope type on both sides, with round holes in the middle. In this way, before the production of the specific mould, we will Carefully check the length, width, thickness, etc. According to the manufacturing method of the prefabricated block of the stay wire disc, the steel mould can adopt two self-made forms, one is the flat form, and the other is the vertical form.

拉線盤鋼模具在使用過后要進行清理的，面板上面不能有附著物，而且如果有暫時用不到的模具的話，可以使用塑料薄膜進行封存，這是為了避免出現受潮而讓表面生銹，這會影響到拉線盤模具的生產效果。拉線盤鋼模具在清理的時候要確保上面沒有殘留的混凝土或者雜質，沒有劃傷痕跡，然后可以在上面噴涂上一層防銹潤滑油，同時還要檢查一下鋼模具的零件，尤其是螺栓的緊固程度，如果有松動要擰緊，如果有損壞要及時進行更換，拉線盤模具在保存期間能夠進行合理保護，才能讓其后期使用不會受到影響。

After use, the steel mould of stay wire disc shall be cleaned, and there shall be no attachment on the panel. If there is mould that can not be used temporarily, it can be sealed with plastic film, which is to avoid rust on the surface due to moisture, which will affect the production effect of stay wire disc mould. When cleaning the steel mould of stay wire disc, make sure that there is no residual concrete or impurity on it, no scratch mark, and then spray a layer of antirust lubricating oil on it. At the same time, check the parts of the steel mould, especially the fastening degree of the bolts. If there is any looseness, tighten them. If there is any damage, replace them in time. The stay wire disc mould can enter during the storage period Only by reasonable protection can its later use not be affected.